Gymrex GR-MG 59 Manual De Instrucciones página 22

a) Attach the machine bases (3, 4) to the side frames (1, 2). For this purpose, use
M12x135 screws, M12 washers and M12 safety nuts.
Slide the washer onto the fastening screw. Align the bracket base and fastener
hole axes. Insert the previously prepared fastener into the hole axis from the
floor side. Secure with a washer and nut from the top. Repeat the procedure
for all holes.
b) Connect the prepared assembly with stabilising fasteners (5, 6). For this
purpose, use M12x75 screws, M12 washers and M12 safety nuts. Guide the
screw from the outside. Fasten using the procedure described in item a) (see
the drawing).
c) Place the main frame (7) with the stabilising fasteners (5, 6). Align the hole
axes. Fasten with M12x135 screws, M12 washers and M12 locknuts. Guide the
screw from the floor. Secure with a washer and nut from the top. Repeat the
procedure for all holes. Fasten using the procedure described in item b) (see
the drawing).
d) Attach the backrest bracket (8) to the side machine frames (1, 2). For this
purpose, use M12x75 screws, M12 washers and M12 safety nuts. Guide the
screw from the inside of the frame. Fasten using the procedure described in
item a) (see the drawing).