Gymrex GR-MG 60 Manual De Instrucciones página 22

a) Fix the fasteners (4, 5) to the side support frame frames (1, 2). For this purpose,
use M12x135 screws, M12 washers and M12 safety nuts.
Slide the washer onto the fastening screw. Align the axes of the support frame
base and fastener holes. Insert the previously prepared mount into the hole
axis, from the outside. Secure with a washer and nut from the inside. Repeat
the procedure for all holes.
b) Place the main frame (6) on fasteners (4, 5) by aligning the holes. Fasten with
M12x135 screws, M12 washers and M12 locknuts. Guide the screw from the
floor upwards. Fasten using the procedure described in item b). Repeat the
procedure for all holes.
c) Place the footrest (7) in the lower section of the main frame. Align the axes of
frame mounting plate and footrest holes. Fasten with M12x30 screws, M12
washers and M12 locknuts. Guide the screw from the outside. Fasten using the
procedure described in item b) (see the drawing).
d) Fix the load holder (3) to the side frame (2) using M12x75 screws, M12 washers
and M12 locknuts. Guide the screw from the inside of the frame. Fasten using
the procedure described in item b) (see the drawing).
e) Use the same procedure to fix the load holder (3) to the side frame (1).