Idiomas disponibles
Idiomas disponibles
Application of strap set
For rectangular shaped in ground pools.
● Open cover over the pool and set into position.
● If you have grommets on the cover, assemble "S3" to it or put strap "S1" through the grommet and then secured by
"S3" (without the screw) as shown in the diagram.
● If there are no grommets, pinch a hole and then attach "S3" through it.
NOTE: Make sure the screw on "S3" is fastened securely.
● Make sure to position "S3" along the cover at the same intervals as the straps are attached to the tube.
● You can adjust the length of the strap by adjusting the strap on the connector "S3".
● Ensure that the length of the straps allows the cover to lay flat on the pool to prevent wind from getting inside under
the cover.
At even intervals, as shown in L1, stick the velcro to the tube.
Locking the Reel / Crank Wheel in position.
● Fasten the threaded knob "#7" to the hole on the top of frame "#1".
04
For round or oval shaped above ground pools.
● Open cover over the pool and fold it as shown in the
diagram. Pinch holes into the cover. 2.5cm away from
the edge, keeping the same regular intervals as on the
tubes. Assemble "S3" to the pinch holes and ensure that
the length of the straps allows the cover to lay flat on
the pool, to prevent wind from getting under the cover.
NOTE: Make sure the screw on "S3" is fastened
securely.
● You can adjust the length of the strap by adjusting
the strap on the connector "S3".
● Ensure that the length of the straps allows the cover
to lay flat on the pool to prevent wind from getting
inside under the cover.
