System Settings; Error Code - URBANGLIDE ECROSS PRO Manual Original

To enter the settings of your product, press the "+" and "-" keys on your screen for 5 seconds.
Caution!
If you change all the basic settings, you will change the performance and status of your product. You
are advised to change only the settings below:
Menu
P01
P02
P04
0 = No sleep mode
P09
ERROR
E06 Check that your battery is fully charged. If so, check that the battery compartment (tray) is not
E07
Check the condition of the cables of your product. Then check the condition of the motor(s).
E08
Check that the throttle trigger is in good condition. Check the condition of your product's cables.
E09
E10
Lost signal, check the condition of your product's cables. This problem may come from the
E11
Lost signal, check the condition of your product's cables. This problem may come from the screen.
E30
Go to the settings of your product by pressing and holding the "+" and "-" buttons. Go to the P20

System settings

Brightness adjustment
Setting the distance measurement unit
0 = KM
Screen saving time
1 à 60 = The number of minutes of standby time
Startup mode
0 = Immediate start

Error code

PROBLEM
damaged. Then check the condition of your product's cables.
Motherboard
Check the condition of your product's cables. Change the motherboard.
Receiving cable
motherboard or the screen.
Transmitter cable
Communication error
setting and enter 0.
28
Setting
1=MILES
1 = Impulse to start
Battery
Motor
Accelerator