STEP
15
NOTE: There may be plumbing or electrical lines in the walls of residential dwellings. Care must be
taken when drilling into walls. If you are not confident in your installation abilities, please consult an
installation professional.
1.Mark hole locations with pencil.
2.At marked locations, drill (4) 1/8" (3mm) holes just through hollow wall 1/2 to 3/4" (12-19mm) deep
or 2" (50mm) deep if wood stud is encountered.
3.Make note on diagram below if a wall stud is encountered during this step. Hollow wall anchor
H200009 must be installed into any hole where stud was not encountered (see step 16). There may
be situations where both hollow wall anchors and long-screw stud anchors are used.
4.Install Wall Anchor into holes where wall stud was not found.
Safety glasses
Gafas de seguridad
Lunettes de protection
Prepare Wall
[ 4 ]
Wall Anchor
X
X
X
X
Hole
