Battery Safety Instructions; Install Battery - CMT ORANGE TOOLS DMM-001 Manual De Instrucciones

DMM-001
Introduction
DMM-001 measures moisture content by detecting a material's electrical resistivity using
two pins. Measurement output is displayed on a practical LCD screen. Tool is easy to operate
and carry and features a low consumption single chip smart design.
Safety Instructions
Failure to follow the instructions listed below may result in bodily injury.
• Please read this manual thoroughly before operating.
• Please do not remove any labels from the unit.
• Do not operate tool in the presence of flammable/explosive gases.
• Be careful about the pins.
• Keep out of the reach of children.
• Place protection cover when not in use to avoid pin damages.
• Cover pins by using the provided caps when not in use to avoid bodily injury.

Battery Safety Instructions

• Please remove battery when cleaning tool.
• Remove battery if you are not using tool for a long time.
• Please install batteries properly as per the instructions of the positive and negative
charges.
• Please dispose batteries properly. High temperature may cause explosions. Do not burn
batteries. Strap insulated tape around the battery charges to avoid unsafe contacts with
other objects. Please follow the local regulations of battery disposal.

Install battery

Remove battery lid on the back of the unit, place a 9V battery block (6F22 or 6LR61)
according to the correct sign marked in the slot, then put back the lid.
Measure moisture
1. Pull out protection cover (A), remove protection caps (K) from the pins.
2. Press power button (G) to switch on tool, LOW LED will turn on and display will show "_ _
_"; default measuring mode is for Wood. Press button (F) to switch the measuring mode.
3. Insert the two detection pins into the target material.
4. Wood mode shows a moisture percentage between 5% and 50%. Below 5% screen will
display "_ _ _", whereas over 50% screen will display "- - -".
5. Building material mode shows a moisture percentage between 1.5% and 33%. Below
1.5% screen will display "_ _ _", whereas over 33% screen will display "- - -".
6. Press HOLD button (I) when measuring. This will store data. Press HOLD button again to
deactivate function.
7. Keep pressing HOLD button (I) to turn off the buzzer sound when measuring.
8. Keep pressing power button for two seconds to switch off tool.
2
Digital Moisture Meter
www.cmtorangetools.com