Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
Charging connection:
Charging your smartGyro
Make sure your smartGyro charger is in good condition. Check that
there is no dust or dirt on the connector, and if so, clean it and make
sure it is dry.
Always use the original charger provided with the product and connect
it correctly to the device (via the charging port) and to a power outlet.
It is important that you always use the charger that comes with your
smartGyro, otherwise it could cause failure of the device and not be
covered by the guarantee. Once the product is put to charge, it will take
about two to three hours to fully charge.
When the LED light turns green, it means the product is fully charged. It
is important that at that time, immediately disconnect the adapter
from the network so that it stops charging.
29
Remove the rubber cap, insert the charging cable. After
charging is complete, put the rubber cap back in place.
Tabla de contenido
