Connection; Volume Control; Pre Setting Information; Connecting To The Web Interface - Optimus MA-215SIP Manual De Instalación Y Funcionamiento

MA-215SIP
SIP AMPLIFIER MODULE
1. CONNECTION
Amplifier SIP module. Unit includes two audio outputs, one for connection to 8 Ω speakers and another for
audio outputs at 0 dB level. The connection must be made as indicated in the following diagram.
Unit is powered through the PoE Splitter supplied with the equipment. Connect the input of the Splitter to
an Ethernet socket with PoE+ and the outputs to the Ethernet socket and power jack of the unit.
Unit also allows direct power supply through an external 12/24V power source (not included). If used, verify
that the output power does not exceed 30 W to avoid overheating.
2. VOLUME CONTROL
Device's volume can be controlled by hardware, through the potentiometer located on the back of
the unit, or by software. The volume controls affect the 0 dB and 8 Ω outputs equally.
3. PRE SETTING INFORMATION
MA‐215SIP can be set from SipManager software or from the webserver. This manual refers to
webserver configuration only.
Webserver is shared among some equipment of the same series, so few menus are unused in this
device.
4. CONNECTING TO THE WEB INTERFACE
The unit's webserver can be accessed by inputting IP address in web browser address field.
The default IP address of the device is 192.168.1.101 The IP address of the computer must be in the
same IP segment to allow the connection.
Note: If the input IP address is found to be incorrect or unknown. You can use the software
SipManager to search, confirm or modify it if necessary.
MA-215SIP Version 1.0 Page 3 of 14