COMMERCIAL STYLE
WALL-MOUNT KITCHEN FAUCET
255-K821-T – Chrome finish
255-K821-SS-T – Stainless steel finish
255-K821-MB-T – Matte black finish
PACKAGE AND HARDWARE CONTENTS
PART
DESCRIPTION
A
Spout
B
Faucet body
C
Spray head
D
Swivel union
E
Flange
F
Rubber washer
Due to constant design and quality improvements, the product
may look slightly different from the picture.
SAFETY INFORMATION
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
WARNING
• Protect your eyes with safety glasses when cutting or soldering water
supply lines.
PREPARATION
Before beginning assembly of product, make sure all parts are present.
Compare parts with the package and hardware contents list. If any part is
missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Adjustable Wrench, Slip Joint
Pliers, Pipe Wrench, Phillips Screwdriver, and Thread Seal Tape.
Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-877-319-3757,
7:30 a.m. - 4:30 p.m., CST, Monday - Friday.
Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • Homewerks.com
QUANTITY
1
1
1
2
2
2
CAUTION
• If you solder the joints during installation of the faucet, the seats,
• Cover the sink drain to avoid losing parts.
Installation may vary depending on how the previous faucet was
installed. Supplies necessary for the installation of the faucet are not
all included; however, they are available wherever plumbing supplies
are sold.
Prior to beginning installation, turn off the hot and cold water lines, then
turn on the old faucet to release built-up pressure. When installing the
new faucet, hand tighten the connector nuts. DO NOT OVERTIGHTEN.
Connections that are too tight will reduce the integrity of the system.
A
B
C
cartridges, and washers must be removed before using a flame
or the warranty will be voided on these parts.
F
D
E
05/2022