Technical Service; Troubleshooting Chart - Husky HDT132 Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Operating Instructions

Air Tool Set-Up

NOTE: It is not recommended to install

a quick coupler between the tool and

the whip hose.

For proper performance and more con-

venience, use a 3/8" I.D. hose. Hoses

longer than 50 feet should have a 1/2"

I.D.

Liquid Flow

Control Valve

Spray

Nozzle

Trigger

1/4" NPT Male

Air Inlet

Figure 1 - Cleaning Gun Features

Troubleshooting Chart

Symptom

Possible Cause(s)

1. Solution buildup

Tool not

siphoning

solution

2. Corrosion

properly

3. Low air pressure

4. Air hose leaks

5. Pressure drops

6. Liquid flow control

valve shut-off

Operation

NOTE: The use of a lubricator is NOT

recommended with this tool.

WARNING

exposure to vibration, work in awk-

ward positions and repetitive work

motions can cause injury to hands and

arms. Stop using any tool if discomfort,

numbness, tingling or pain occur, and

consult a physician.

1. Connect the solution hose to the

barb fitting.

2. Place material strainer end of hose

Barb

into the solution being sprayed.

Fitting

3. Connect to air supply.

4. Pull the trigger and allow approxi-

mately 5 seconds for the solution to

reach the spray nozzle. Release the

trigger to stop the flow.

5. Adjust liquid flow control valve to

obtain desired solution flow.

Corrective Action

1. Remove by flushing with warm water

2. Disconnect hose from tool and add two drops of mineral spirits through the

barb fitting on the tool after each use (See Figure 1)

3. Adjust the compressor regulator to tool maximum (90 psi) while the tool is

blowing air

4. Tighten and seal hose fittings if leaks are found

5a. Be sure the hose is the proper size. Long hoses or tools using large volumes of

air may require a hose with an I.D. of 1/2" or larger depending on the total

length of the hose

5b. Do not use a multiple number of hoses connected together with quick connect

fittings. This causes additional pressure drops and reduces the tool power. Di-

rectly connect the hoses together

6. Adjust liquid flow control valve to desired flow

STORAGE

The cleaning gun must be thoroughly

flushed with water before storing.

Refer to cleaning solution Material

Do not misuse this

Safety Data Sheet (MSDS)

product. Excessive