Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4.Installation
4.1 Important SAFETY WARNINGS and Instructions
IMPORTANT SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
！
WARNING
Danger of electrical shock or injury. Turn OFF power at the panel board or load center before working
inside the equipment or removing any component . Do not remove circuit protective devices or any other
component until the power is turned OFF.
This Charging Station should be installed only by a licensed contractor, and/or a licensed electrician or trained
installation expert in accordance with all applicable state, local and national electrical codes and standards.
Before installing this Charging Station, review this manual carefully and consult with a licensed contractor,
licensed electrician, or trained installation expert to ensure compliance with local building practices, climate
conditions, safety standards, and state and local codes.
4.2 Grounding Instructions
This product must be connected to a grounded, metal, permanent wiring system; or an equipment grounding
conductor must be run with the circuit conductors and connected to the equipment grounding terminal or
lead on the product.
4.3 Recommended Tools
The following tools are recommended for this Charging Station installation:
• Installer-supplied components:
-Conduit of appropriate trade size for power wire
-Four (4) expansion screws for securing the main body mounting bracket to the wall
-Four (2) M6*10 hexagon socket cap screws to the back of the box
-One (1) M6*10 cross round head with washer screw securing box to the bracket
-One (1) Key for RCD configuration
• Recommended tools:
-Screw driver
05
Tabla de contenido
