Assembly And Usage - Joovy Zoom Manual De Instrucciones

Assembly and Usage

Unpacking the Product
• Remove everything from the box – Zoom 360 Car Seat Adapter, Velcro straps (4), and documents
(not shown).
• Discard all packaging materials properly including plastic coverings.
• DO NOT allow children to play with any packaging materials.
Installing the Adapter and Car Seat
• Unsnap the five snaps located on BOTH sides of the seat. (1)
• Fold the fabric inside and under the stroller frame tubes so that the tubes are clearly exposed on
both sides of the stroller. (2)
• Position the canopy so it is opened halfway. Recline the seat to its maximum recline position. (3)
• Open all four clamps on the adapter.
• Place the car seat adapter on the stroller frame tubes so that the canopy hinge brackets are
between the adapter clamps. (4)
DO NOT allow any of the seat fabric to be captured by the clamp.
• Close all four clamps around the stroller frame tubes. (5) Make sure that all four clamps are fully
closed and no seat fabric is captured by the clamps.
• Attach the slotted end of one Velcro® strap between one adapter clamp and the seat fabric.
Attach the loop around the tab on the clamp. (6)
• Wrap the Velcro® strap tightly around the clamp (7) and ensure that the middle loop of the Velcro®
strap fits over the clamp tab. (8)
• Continue wrapping tightly until the entire length of the Velcro® strap is secured together. Make
sure the edges of the Velcro® strap are aligned for maximum strength. (9)
• Repeat for the other three clamps and Velcro® straps.
• Close the canopy completely. Attach the two sets of snaps found on the underside of the canopy. (10)
• Unbuckle the restraining strap buckle by pressing the center and both side release buttons. (11)
• Hold the car seat by the carry handle. Orient the car seat so that it faces the rear of the stroller and lower
the car seat onto the adapter.
• Adjust the stroller seatback upwards until it can firmly support the car seat. (12)
• Pull each side of the restraining strap up and over the car seat and the baby. Buckle the
restraining straps over the LOWEST part of the car seat and over the baby. (13)
• Adjust the straps so they are tight around the car seat but AWAY from the child's neck. Pull up on
the infant car seat to ensure it is secure.
I WARNING:
clamps are secure and all Velcro® straps are fully attached.
Removing the Car Seat and Adapter
• To remove the car seat and adapter, first position the canopy so it is opened halfway.
• Unbuckle the restraining strap buckle and remove your baby from the car seat. Rebuckle the
restraining straps together.
• Grasp the car seat handle and pull the car seat up and off the adapter.
• Remove the Velcro® straps from all four clamps and place the straps into a plastic bag or connect
them together for storage.
• Open all four clamps and remove the adapter from the stroller. Then close all clamps.
• Store the adapter and Velcro straps for future use.
• IMPORTANT: Wrap the seat fabric over the stroller frame tubes and reattach the five snaps
located on BOTH sides of the stroller.
Before each use, check to make sure all four
5