Fig. A
Water connection
Fig. B
Tools needed
•
Flat-Head Screwdriver
•
1/2-inch Wrench
•
Cutting tool, such as sharp knife, wire cutters or squeeze-
type tubing cutters
Notes
•
Read all instructions before beginning work.
•
Having your Thetford Permanent RV Toilet Owner's Manual
to consult is beneficial.
•
Not all hardware in package may be needed.
•
If necessary, remove toilet from floor. For Bravura, this
may be avoided: to gain access to Water Saver, remove
Seat/Cover/Pod Assembly by opening lid and seat and
pulling straight up.
(AMV shown)
Hose
Barb
Thetford Corporation
Screw
Ann Arbor, MI 48106 •
Clamp
Removing Existing Hand Sprayer:
1. Turn off RV water supply per RV owner's manual
2. If necessary, disconnect water supply line (Fig. A).
3. Unscrew clamp on hose barb (Fig. B).
4. Pull Hose off Barb to free old Hand Sprayer. Discard clamp
To Install New Hand Sprayer:
1. Locate Hose Barb on Water Module (Fig. A).
2. (If not already cut) using a cutting tool, cut off bottom
3. Place new clamp over spray hose. Push hose firmly onto
4. Position clamp over hose and hose barb. Tighten (Fig. B).
5. Install Spray Head Holder on Wall or Toilet (Bravura
If Removed From Floor, Reinstall Toilet
Making Sure to Use New Closet Flange Seal
Parts/Pièces/Particulos
RV Toilets/cabinets permanents/inodoros
Aqua-Magic
Hand Spray Kit
Trousse de douchette
Made in U.S.A./Fabriqué aux É.-U./Hecho en EE.UU.
1-800-521-3032
and old sprayer.
part of hose barb between 2 ribs (Fig. A).
hose barb.
Only).
Part No.
33226
No de pièce
particulo No.
V, Bravura
®
®
• www.thetford.com