Cleaning And Maintenance - Asist AE8G220DN Instrucciones De Uso

Electric
drive
Refrigerator
Refrigerator
150W
Electric
ventilator

CLEANING AND MAINTENANCE

CAUTION: Before performing any maintenance, stop
the engine, allow it to cool, and disconnect the ignition
cable from the spark plug.
-! Do not replace generator parts, perform repairs
yourself, or otherwise interfere with the machine de-
sign. Product repair may only be performed by trained
personnel, resp. authorized service organization.
- Regularly check the generator for damage.
- Regularly remove dust and dirt from the generator
- Store the generator in a dry place and out of reach
of children.
- Never clean any part of the generator with a hard,
sharp or rough object.
- Cleaning is best done with a soft brush or cloth.
- When shutting down for a long time, remove the fuel
from the generator.
Oil change
- If the engine is warm (not hot)! - Remove the drain
plug and washer. Drain the oil into a suitable contai-
ner. - Replace the washer and the drain plug.
- Place the generator on a level surface. Remove
the oil dipstick and pour new oil into the tank. Do not
overfill the oil tank.
- Push the measuring cup back in and seal it.
- For a new engine, change the engine oil after the
first 5-8 hours of operation
CAUTION - Avoid excessive contact of your skin with
engine oil. Wear gloves when working and wash your
hands thoroughly after work!
Air filter
-! A dirty air filter prevents the passage of air, which
results in a reduction in engine power. Therefore,
clean the filter regularly.
- Remove the screws, remove the filter cover and
remove the filter
Remove the foam insert of the air filter, clean it well in
kerosene, squeeze and dry.
Gently moisten it with clean engine oil.
-! If the filter is torn, damaged or cannot be cleaned,
replace it with a new one.
Spark plug check
WARNING:
Before replacing or checking the spark plug, switch
off the engine and let it cool down!
The spark plug must be clean and with the correct
distance between the contacts to achieve efficient
engine operation.
Disconnect the cable connector from the spark plug.
(x3-6)
(x2)
450
300W
-750W
Unscrew the spark plug using the spark plug wrench.
Do not use any other tools.
Visually inspect the spark plug. If it is damaged, repla-
ce it with a new one (recommended distance between
contacts is 0.70mm - 0.80mm). The recommended
type of spark plug is F6TC.
Do not bend the center electrode to change the gap.
Screw in the spark plug with a torque of 25 Nm - 30
Nm
! Improper tightening of the spark plug can result in
reduced engine power or permanent engine damage.
Fuel filter maintenance
Set the fuel cock to the „OFF" position.
Thoroughly clean the fuel filter container, blow it out
with compressed air in the direction of the arrow.
Firmly install the new rubber pad and filter bowl.
Spark plug
Engine oil
Air filter
Fuel filter
Will
Fuel route
Exhaust system
Carburetor
Cooling system
Starting system
Decarbonization
59
Check the condition, adjust
A the slit and clean.
Replace if necessary.
B1 Check the oil level
B2 Replace.
C Clean up. Replace if
necessary.
Clean the fuel cap filter.
D Replace if necessary..
E
Check and adjust only when
the engine is cold.
F
Inspect the fuel hose for
cracks or other damage.
Replace if necessary.
Check for leaks.
G1 Tighten or replace seals if
necessary.
Check the shock absorber
G2 wall.
Clean / replace if necessary.
H Check the carburetor choke.
I Check for damage.
J Check starter operation.
K More often if needed