Set-Up Before Use; Telescopic Pole (Not Included) Assembly; Specific Telescopic Pole (Not Included) Assembly - Kokido VOLTERA 25 Manual De Usuario

Once the lifespan of the battery reaches its end, refer to section "BATTERY DISPOSAL"
for instructions regarding battery disposal.
NOTE: Let the pool vacuum rest for 30 to 40 minutes before charging it again.

Set-Up Before Use

Telescopic pole (not included) assembly

(only for EU and USA)
Press down the side pins of the telescopic pole connector and insert it inside the main
body. Turn the connector in either direction until the pin is secured in the hole, as shown
in the diagram.
Slide the telescopic pole onto the pole connector. Press on the side pins of the connector
and slide the telescopic pole further down until the pins of the connector are secured
inside the holes of the pole.
To release the telescopic pole, press down the side pins simultaneously and pull out the
pole.

Specific Telescopic pole (not included) assembly

(only for Australia & New Zealand)
Insert the end (with two side pins) of the specific telescopic pole connector into the pool
vacuum as shown until its side pins are secured to the pole connector's locking hole on
the rear body. To install the specific telescopic pole (with internal wishbone clip) to the
pole connector as shown:
12