Unpacking Instruction; Front Panel; Rear Panel - Fenton AV-150BT Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.

FRONT PANEL

1. Power switch - Press the switch to turn the amplifier on/off.
2. Echo control - Turn this knob to adjust the microphone echo effect.
3. Microphone volume - Adjust the volume of the microphones.
4. SD card slot - Insert your SD Card to play MP3 files.
5. USB port - Insert your USB devices into this slot.
Microphone inputs - 6.35mm (1/4") jack inputs for connecting microphones.
6.
7. Control buttons
Mode - Press this button to change between USB/SD, FM and BT mode. USB/SD is default mode.
Play / Pause - Start/resume or pause play by pressing this button.
Stop - Press this button to stop play in USB/SD mode.
Repeat / Folder - Allows you to set one of the repeat modes:
ALL-- All tracks in the USB or SD CARD will be repeated in order without interruption.
NORMAL-- All tracks in USB or SD mode will be played in order without interruption, play will stop after the
last track.
SINGLE-- Repeat the current track.
FOLDER-- All tracks in the current folder will be repeated in order without interruption.
RANDOM-- All tracks in USB or SD CARD mode will be played in random order.
BROWSE-- All tracks in USB or SD CARD mode will be played for 10 seconds in order without interruption.
Hold this button for 3 seconds to enter FOLDER mode, "FOLDER" will flash on the display. Use the PREVIOUS and
NEXT buttons to navigate through different folders. Hold the button for 3 seconds again to exit the mode.
Previous - Skip to previous track in TRACK mode. Select the previous folder in FOLDER mode.
Next - Skip to next track in TRACK mode. Select the next folder in FOLDER mode.
8. Bass control - Adjust the bass.
9. Treble control - Adjust the treble.
10. Balance - To adjust the balance between the left and right channel.
11. Volume control - Adjust the output level of amplifier.
12. Sub volume - Adjust the volume of the subwoofer output.
13. Source switch - Turn to choose the input source to play.
14. Aux input - Connect any stereo signal such as a CD, TAPE, Mixer etc. to this input. To play a signal connected to this
input make sure the AUX input is selected by setting the source switch correctly.

REAR PANEL

15. Subwoofer output - RCA line level output to connect an additional active subwoofer or extra amplifier.
16. Audio input - Connect the audio output RCA jacks of (for example) DVD/CD, to these RCA jacks.
17. Surround output - Spring loaded to terminals to connect surround and centre speakers.
18. Main output - Use the combo screw speaker jacks to connect the left and right speakers.
19. BT antenna - Pull the antenna out when using the BT input.
20. FM antenna - Connector for an FM antenna.
4