Battery Status; Charging The Jumpboost; Ac Charging; Dc Charging In Your Vehicle Or Boat - Wagan Tech JumpBoost V6 Air Manual De Usuario

JumpBoost™ V6 Air by Wagan Tech

BATTERY STATUS

The color LED indicators on the front of the unit provide the current state of charge on the internal
battery. It is the user's responsibility to periodically monitor the battery's status and recharge
every 3 months in addition to recharging after each use.
1. Disconnect any input or output power cords and turn off all switches.
2. Press and hold the Battery Status button.
3. Observe the color LED indicators to determine battery status.
• Red (only): Battery is discharged. Charge immediately.
• Red and Yellow: Battery should be charged before jumpstarting a vehicle
• Red-Yellow-Green: Partially discharged; recharge when practical.
• Red-Yellow-Green-Green: Battery is fully charged when all lights are lit

CHARGING THE JUMPBOOST

ELECTRICAL SHOCK! Exposure to water may cause electrical shock� Exposure to
water and excessive moisture will also damage the unit and void the warranty�
Charge your JumpBoost in an upright position for a full 48 hours before initial use� Continue
to maintain the life of your JumpBoost (as with all lead-acid batteries) by fully recharging the unit
every 3 months even if the JumpBoost has not been used.

AC Charging

Only use the AC charging adapter supplied with this unit� Make sure the supplied AC/DC
charging adapter is to be powered by the correct voltage (110V AC or 220V AC depending on
your country/region).
1. Make sure all JumpBoost switches are off.
2. Plug the DC end of the AC/DC charging adapter into the JumpBoost's charging jack.
3. Connect the AC end of the AC/DC charging adapter to the wall outlet.
4. The Charging Indicator will light up during the charging process. The JumpBoost can be
charged continuously via AC adapter without damaging the internal battery.
5. When charging is complete, the Full indicator will illuminate. Disconnect the adapter from
the AC outlet first, then from the charging jack.
6. Press the Battery Status Button and observe the Battery Status Indicators for the state of
charge on the unit's internal battery.

DC Charging in Your Vehicle or Boat

Only use the DC charging adapter supplied with this unit� Your vehicle engine must be running
while charging the Battery Jumper. Do NOT exceed 12 hours of continuous charging time.
1. Make sure all Battery Jumper switches are off.
2. Plug the small end of the DC power cord into the JumpBoost's charging jack.
10
®
www.wagan.com