Flo 89611 Manual página 11

GB
an obstacle with shoulder straps, which can lead to serious injuries.
The shoulder straps must be attached to the openings near the inlet and on both sides of the tank using clip hooks. The shoulder
straps should be hooked in such a way that the sprayer can be worn as a backpack. The shoulder straps are equipped with an
additional chest strap. Adjust the shoulder straps length in such a way that the sprayer does not move on the back, but also that
the shoulder straps do not exert excessive pressure on the body. Fasten the chest strap and adjust its length so that it pulls the
shoulder straps slightly towards itself. This will relieve the shoulders and distribute the weight more evenly on the back.
Caution! Do not handle the sprayer on one shoulder strap. Do not cross shoulder straps.
Caution! When using the shoulder straps, fi rst put the sprayer on the back and only then start the pump by pressing the power
switch. It is forbidden to install or remove the sprayer with the pump running.
Finishing the work
After fi nishing the work, stop the sprayer in the following order. Release the pressure on the lance trigger, unlock the trigger if the
lock has been used. Check that the jet has stopped coming out of the nozzle. Switch the sprayer's pump by moving the power
switch to the off position – O. Point the nozzle outlet at a safe place and press the trigger to release the liquid under pressure
accumulated in the sprayer system. Release the pressure on the trigger after the jet has stopped coming out. Remove the sprayer
from the back if the shoulder straps have been used. Disconnect the battery and keep it away from the sprayer. Open the tank
inlet cap, remove the inlet fi lter and empty the sprayer tank through the inlet.
After completing all these steps, proceed with the device maintenance.
MAINTENANCE, TRANSPORT AND STORAGE
Caution! Disconnect the device from the power supply before performing any works described below. Move the switch to the "off "
position - O.
After each use, empty the tank and leave it open to dry completely. If other liquid than clean water was used for spraying, the tank
should be rinsed with clean water. After rinsing, fi ll the tank with clean water and start the sprayer for approx. 1 minute, pointing
the nozzle outlet at a safe place. This will remove residues of liquid used for spraying from the sprayer system. This operation is
not necessary if clean water has been used for spraying.
Clean the inlet fi lter under running, lukewarm water and leave to dry completely.
Remove the lance and nozzle from the holder and leave to dry completely, then reassemble the lances and nozzles with the
handle.
Store the product in a place that provides good ventilation and protects against direct sunlight and precipitation. The place of stor-
age should protect the device from access by unauthorised persons, especially children. Do not store the sprayer at temperatures
below 0 C or above 40 C. Freezing water inside the sprayer may result in damage.
° °
If the nozzle is completely or partially clogged, you can attempt to clean its outlet with a needle smaller in diameter than the noz-
zle outlet. In case of failure, replace the nozzle. Make sure that the nozzle outlet does not have contact with the ground or other
places where it could get dirty.
Handle the sprayer by holding the handle or on the back with shoulder straps. Transport the sprayer in the supplied packaging
over longer distances. Do not place anything on the sprayer during transport.
O R I G I N A L I N S T R U C T I O N S
11