ROBLIN INFINITY Modo De Empleo página 8

G B G B
When the crossed-out wheelie bin symbol is attached to a product, it means that the product is covered by European
Directive 2002/96/EC.
Your product is designed and manufactured using high-quality materials and components which can be recycled and used
again.
• Please take time to enquire about your local electrical and electronic waste sorting system.
• Please respect local regulations and do not dispose of your used products with everyday household waste.
• If you dispose of your used product in the correct way, you will help to prevent any potential adverse
effects against the environment and human health.
This appliance should not be used by anyone (including children) with reduced psychic, sensory or mental capacities or
by anyone who does not have experience and knowledge of this type of appliance, unless they are under the control and
guidance of those responsible for their safety. Special care should be taken to make sure that children do not play with
The appliance should be assembled and connected by a qualified fitter*.
Use the pegs adapted to the support structure; consult manufacturers for details; seal if necessary. The company does not
accept responsibility for any attachment fault due to drilling and pegging.
GB
The hood is fitted with a 3 x 0.75 mm² HO5VVF power cord including a standardised 10/16 A plug with an earthing system.
Type of protection: category 1
Power supply voltage: 220-240V mono - 50/60Hz.
Check that the voltage of the supply circuit is identical to the values indicated on the descriptive plate inside the hood.
If the hood is directly connected to the network (without its plug), an omnipolar switch with a 3mm contact point-gap should
be installed just before the hood. The earth wire (yellow and green wire) should not be interrupted by this switch.
• For the appliance to operate effectively, we advise you to establish a height installation 0.40m over the hob. However,
it is expressly forbidden to install any hood or suction unit at a distance under 0.40m from the hob (risk of the filters
catching fire). Fumes should rise naturally towards the extraction area.
• Respect the outlet diameter of the appliance: the hood should under no circumstances be connected to a controlled
mechanical ventilation duct.
• When the exhaust air is discharged in an exhaust duct, make sure that the duct is not already being used to channel
gases or fumes from any appliances powered by any energy other than electricity.
• Place the hob as close as possible to the exhaust and prevent the build-up of crimps on the sheath in order to reduce
These instructions are valid for several versions of the appliance.
They may contain descriptions of accessories which do not ap-
pear in your appliance.
THIS EQUIPMENT COMPLIES WITH THE FOLLOWING REGULATIONS:
2006/95/EC on electrical safety, 2004/108/EC on electromagnetic compat-
ibility, 93/98 on marking, 65/2014 on energy labelling 2010/30/EU 66/2014
on ecodesign 2009/125/EC, IEC 60704-2-13, IEC 60335-2-31 IEC 60335-1
ASSEMBLY RECOMMENDATION
*any failure to meet this condition invalidates the manufacturer's warranty and any action in the event of an accident.
the appliance.