Welch Allyn LS200 Manual Del Propietário página 9

5. Remove wall plate and use a center punch to start hole.
6. Using a hammer drill and 5/32" (4mm) masonry drill bit, drill
hole to a minimum of 1.5" (4cm) deep.
7. Place wall plate on wall and drive 1.25" (3.2cm) masonry
screw halfway into the wall.
8. Align wall plate using a level and secure by tightening screw.
9. Punch the next three
holes with wall plate
in place.
10. Drill remaining holes.
11. Fasten wall plate
with three remaining
screws.
12. Prepare for transformer
mounting by following
"Transformer Mounting"
instructions through step 4
on page 8.
13. Carefully remove LS200 arm/lumi-
naire assembly from box. Complete
transformer mounting by following
steps 5 & 6 of instructions on page 8.
14. Place arm/luminaire assembly on
extension arm by sliding universal
connector (B) onto extension arm (G)
and aligning screw holes.
15. Insert 0.5" (13mm) flathead screw (b) into hole on
side of universal connector and tighten.
Move arm up and down to check that mounting is secure.
16. Push cord into clips in underside of extension arm.
LEVEL
(b)
7
EXTENSION
ARM (G)
ARM/
LUMINAiRE
ASSEMBLY
UNIVERSAL
CONNECTOR
(B)
EXTENSION
ARM (G)