Connecting To Wifi - ProBreeze PB-15 Manual De Instrucciones

Display
•
As a default, the LED display will show
the RH (relative humidity) of the room to
+/- 5%accuracy.
•
If there is a problem with the unit, the
following will display:
• P2: water tank is full or not in the
right position. Empty the water tank
or check its positioning.
• AP: device is in auto-pairing
mode, which is used to connect
to wifi. This mode should turn off
automatically within 8 minutes.
• AS: humidity sensor error. Unplug
the unit, wait 30 seconds and plug
back in. If the problem persists,
contact support.
• ES: tube temperature sensor error.
Unplug the unit, wait 30 seconds
and plug back in. If the problem
persists, contact support.
7 | English

CONNECTING TO WIFI

― ―
Note: if you are having issues connecting
to Wifi, please ensure your network is set to
2.4G. If you are continuing to have issues,
please contact our customer care team by
emailing [email protected]
• To connect to WiFi, hold the filter button
down for 3 seconds, or until the LED
display shows "AP" (auto-pairing). When
in auto-pairing, the compressor will be
forced off.
• Ensure the dehumidifier and your mobile
are connected to the same WiFi.
• Download the "NetHome plus" app.
You will have to create an account.
On screen, select "add device" and
then select "dehumidifier". Follow the
instructions on the app.
• When the connection is successful,
the dehumidifier will automatically turn
back on.
• If after 8 minutes the connection is
unsuccessful, the dehumidifier will
automatically turn back on. Start the
connection process from the beginning.
• Once connected, you can view
performance and control your
dehumidifier through the app.