Safety Instructions; Machine Information - VONROC WL508AC Traducción De Las Instrucciones Originales

EN

1. SAFETY INSTRUCTIONS

Read the enclosed safety warnings, the additional
safety warnings and the instructions. Failure to
follow the safety warnings and the instructions may
result in electric shock, fi re and/or serious injury.
Save the safety warnings and the instructions for
future reference.
The following symbols are used in the user manual
or on the product:
Read the user manual.
Denotes risk of personal injury, loss of life
or damage to the tool in case of non-
observance of the instructions in this
manual.
Risk of electric shock.
Not suitable for applications with external
dimmers.
Minimal distance between the light source
and illuminated objects.
Protection class IP65.
Replace damaged glass covers.
Do not dispose of the product in unsuitable containers.
The product is in accordance with the
applicable safety standards in the European
directives.
SAFETY WARNINGS FOR WORK LIGHT
a) Please read and observe all safety warnings
and instructions enclosed with the fl ood light.
b) Do not use the fl ood light in hazardous areas. c) Do not direct the light beam at persons or
animals and do not stare into the light beam
yourself (not even from a distance).
d) Do not cover off the lens while operating the
fl ood light. The fl ood light heats up during operation and can cause burns when the heat is
allowed to accumulate.
e) Do not allow children to use the fl ood light.
It is intended for professional use. Children
can unintentionally blind themselves or other
persons.
4
2. ASSEMBLY
Place the tripod stand (Fig. B)
1) Loosen the locking screw (6).
2) Fully extend the tripod legs (7).
3) Re-tighten the locking screw (6).
4) Place the tripod stand on a stable, level surface.
The tripod legs (7) must always be fully
extended to ensure the stability of the
tripod and prevent the fl ood light from
tipping over / falling.
Install the support bar (Fig. C)
1) Position the support bar (4) on top of the tripod
stand. Align the center hole of the support bar
with the tripod stand.
2) Fix the support bar (4) in place by installing a
locking screw (3) through the center hole.
Install the lights (Fig. D-1, D-2)
1) Position a light (1) on both ends of the support
bar (4). Align the hole in the light brackets with
the hole on each end of the support bar.
2) Fix the lights (1) in place by installing a locking
screw (3) through the hole in the light brackets.
3) Attach the cable splitter (8) to the support bar
(4) using the screw (9).

3. MACHINE INFORMATION

Intended use The twin fl ood light is intended as mobile
illumination for temporary use and is not suitable
for permanent room lighting.
TECHNICAL SPECIFICATIONS
Model No.
Input
Power
Luminous fl ux
Beam angle
Weight
Height
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. LED light
2. Locking screw
WL508AC
220-240V~ 50Hz
2x 50W (100W total)
2x 4250lm (8500lm total)
o
100
3.6kg
84-176cm
WWW.VONROC.COM