Installation Instructions - MHTeam DH2-I-20C Manual De Instrucciones

1、Insert the wheel shaft H to the corresponding hole of low tube frame J，insert the spacer F, slide the wheel G
over the wheels shaft H and fix them by using spring washer E.
2、Put the heater body D on the low tube frame assembly, make sure the holes of handle A point towards the
corresponding holes on the low tube frame respectively.
3、Using the screw C and nut M5 I to fix the low tube frame assembly and handle to the tank.

5. Installation Instructions

Position the heater on a flat, level, non-
flammable, solid surface.
The exhaust gases are very harmful for
people and animals when released in a
closed space without ventilation.
Indirect-fired heaters while used in indoor
installation, must be connected to an
exhaust pipe to vent the products of
combustion
adequate Oxygen rate, a minimum of 80
m 3 /h airflow from outside must be ensured.
For indirect fired heaters: connect the heater
to a chimney or to an exhaust duct L. To get
a proper draught in the chimney the exhaust
gas path must rise. Avoid any elbows and
bends in the first part of the exhaust ducts
for at least 3 m.

Only install the heater in normal upright position.

Do not place the heater near walls, corners or low ceilings.

Do not place the heater below a socket outlet.

Do not place the heater on moving vehicles or where it can tip over.

Keep the heater away from flammable, combustible, explosive or corrosive materials.

Keep the heater away from curtains or similar materials that could block the air inlet and outlet.

Never block or restrict the air inlet and outlet for any reason.

Keep the power cable away from heat sources, sharp edges, cutting and moving parts.

Do not expose directly to the weather or to excessive humidity.

Do not place the heater in the immediate surroundings of a bath, shower or swimming pool.

Follow general and special fire safety regulations in force in all fields of applications. In any case
ensure the following minimum safety clearances from materials or objects in the surroundings of
the heater:

Floors and ceilings must be made of fireproof materials in the place where the heater is operated.
outside. To maintain
 Side:

Air inlet side:

Top:

Hot air outlet side:

Floor:
an
0.6 m
1 m
1.5 m
3 m
0 m