Silverline 991471 Manual De Instrucciones página 13

EN
8. Pivot the saw on the tip of the Base Plate until the Blade
contacts the workpiece (Fig. IX (c))
9. Release the Blade Guard
10. Continue to pivot slowly, until the Blade has fully
penetrated the thickness of the workpiece
9. Once the face of the Base Plate is flat against the
workpiece, continue to make the cut
Using the parallel guide
1. To follow an edge, keep the vertical foot of the Parallel
Guide, pressed against the vertical edge of the workpiece,
as the cut is made (Fig. X)
2. Do a test on a scrap workpiece to check the distance
Accessories
• A full range of accessories including circular saw blades,
straight edges and rip-cut guides, is available from your
Silverline stockist
•
Spare parts can be obtained from toolsparesonline.com
Maintenance
WARNING: Always disconnect the tool from the power supply, before
cleaning or carrying out maintenance.
General inspection
•
Regularly check that all the fixing screws are tight. They may
vibrate loose over time
•
Repairs should be carried out by an authorised Silverline
service centre.
Lubrication
•
Lubricate all moving parts with a suitable lubricant spray, at
regular intervals
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection
and gloves when cleaning this tool.
•
Keep your tool clean at all times. Dirt and dust will cause
internal parts to wear quickly, and shorten the device's
service life
•
Clean the body of your tool with a soft brush, or dry cloth
•
Never use caustic agents to clean plastic parts. If dry
cleaning is not sufficient, a mild detergent on a damp cloth
is recommended
•
Water must never come into contact with the tool
•
Ensure the tool is thoroughly dry before using it
•
If available, use clean, dry, compressed air to blow through
the ventilation holes (where applicable)
Brushes
•
Over time the carbon brushes inside the motor may
become worn
•
Excessively worn brushes may cause loss of power,
intermittent failure, or visible sparking
•
If you suspect that the brushes may be worn, have them
replaced at an authorised service centre
Contact
For technical or repair service advice, please contact the helpline on
(+44) 1935 382 222
Web: silverlinetools.com/en-GB/Support
UK Address:
Toolstream Ltd. Boundary Way. Lufton Trading Estate. Yeovil, Somerset.
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V. De Keten, 00004, 5651 GJ, Eindhoven, Netherlands
Storage
•
Store this tool carefully in a secure, dry place out of the
reach of children
•
For long-term storage, remove batteries and store
separately
Disposal
Li-ion batteries should not be disposed of with household waste. If you do
not know of a li-ion battery recycling centre in your area, contact your local
authority or original dealer for advice on disposal of li-ion batteries.
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
•
Do not dispose of power tools, batteries or other waste
electrical and electronic equipment (WEEE), with household
waste
• Contact your local waste disposal authority for information
on the correct way to dispose of power tools and batteries
silverlinetools.com
Original Instructions
13