VONROC PM506DC Traducción Del Manual Original página 8

EN
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first
use.
Inserting the battery into the machine (Fig. D)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (11) into the base of the ma-
chine like shown in Fig. D.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. D)
1. Push the battery unlock button (12).
2. Pull the battery out of the machine like shown
in Fig. D.
Checking the battery charging status (Fig. E)
• To check the battery charge status, push the
button (13) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more charge
the battery has left.
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the charger (Fig. E)
1. Take the battery (11) from the machine.
2. Turn the battery (11) to upside down position
and slide it onto the charger (15) as shown in
Fig. E.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on the
charger (14) will lighten up and show the char-
ger status.
8
The charger has 2 LED indicators (16) which indi­
cate the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the char-
ger plug from the outlet and remove the battery
from the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Assembling the two­part whisk (Fig. A)
1. Screw the Whisk shaft (5) onto the Whisk pad-
dle (6)
2. Tighten both parts securely
Replacing the whisk (Fig. C)
Always remove the battery before mounting
an accessory.
Use only whisks conform the specified diameter.
Always use a whisk that is suitable for the material
to be mixed/stirred. Using an unsuitable mixer bar
can unnecessarily overload both the machine and
yourself.
Mounting the whisk
1. Screw the assembled whisk into the tool holder
(4) in clockwise direction as far as possible.
2. Tighten the whisk into the tool holder using the
supplied spanners (10). To do so, hold the tool
holder (4) using one of the supplied spanners,
and use the second spanner to tighten the
assembled whisk.
Charger status
No power
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
finished
Battery charging in
progress
WWW.VONROC.COM