EN
INSTALLING IN THE VEHICLE
I
1 2
E
D E
2 3
3 4
H
E
FOR INSTALLATION WITHOUT ISOFIX, START HERE!
5 6
facing vehicle seats). The entire back surface
of the Charlie seat must be in contact with the
backrest of the vehicle's seat.
INSTALLATION WITH ISOFIX
1
If needed, place the two ISOFIX
guides (
) on both ISOFIX anchor
I
points between the seat and
the backrest.
Extend the ISOFIX connectors (
by pulling the ISOFIX release puller
(
) in the front of the seat.
The ISOFIX connectors will slide to
their outermost position.
Position the child seat on the seat
in the car and insert both connectors
into the ISOFIX anchor points until you
hear a "click".
Check that the ISOFIX safety
indicators (
G H
Pull the ISOFIX release puller (
5
again and...
...push the bottom part of the child
seat against the vehicle seat until it is
firmly positioned and tight to the seat.
If the headrest of the vehicle seat is
interfering with the child seat, adjust
the headrest or remove it completely
(do not remove the headrest in rear-
) have turned green.
5
)
E
F
)
D E