Tabla de contenido
Do not attempt to replace the batteries used in this product with any other type of
battery. The battery pack is replaceable, however care should be taken when doing so.
Follow these steps when replacement is required:
1. Always remove the charging adaptor from the unit before removing the battery.
2. Remove the single screw securing the battery compartment cover located on the
bottom of the unit.
3. Remove the cover of the battery compartment. Never open the battery
compartment except to change the battery.
4. Carefully lift out the battery pack and disconnect the terminals.
5. Connect the terminals to the new battery pack.
6. Tuck the wiring inside the battery compartment so that the wiring does not
interfere with the battery compartment cover when it is replaced.
7. Re-install the battery pack and close the battery compartment cover with the
screw.
WARNING:
•
Only use the hand vac with the battery pack supplied with the unit. Also, never
use ordinary batteries for replacement, as these may leak and damage your
vacuum cleaner. Only use battery packs sold by your vendor.
•
Never use the unit without the battery compartment cover in place.
•
Any other servicing should be performed by an authorized service representative.
•
Do not attempt to remove the battery pack from the unit to charge it.
•
Never throw the battery pack or unit into a fire or incinerate it.
WALL MOUNT
1. Make sure that the wall area for the charging base to be mounted is free from any
hidden electrical wires, water pipes and gas lines.
2. Select an appropriate place close to a wall power outlet.
3. Do not mount near direct sunlight, near a heat source or outdoors.
4. Carefully measure and mark the location of where the holes should be drilled,
according to the placement of the 2 mounting holes in the charging base. Then
drill holes and screw the charging base onto the wall.
43
DO211S
Tabla de contenido
