Power On/Off; Bluetooth Connection; Restore To Factory Settings - EDIFIER HECATE G33 BT Manual De Instrucciones

User guide
Power on/off
• When the headset is powered off, press and hold the "
headset will power on.
• When the headset is powered on, press and hold the "
headset will power off.

Bluetooth connection

When the headset is powered off, press and hold the "
•
Bluetooth pairing state (the red and blue lights flashing alternately); set Bluetooth device to
search for and connect to "HECATE G33BT", after pairing is successful, the blue light will flash
slowly.
• When the headset is powered on and not connected with any devices, press and hold the "
button for 2 seconds to let it enter Bluetooth pairing state.
• It is Bluetooth pairing state by default when the headset is powered on for the first time, and
it will auto-connect to the Bluetooth device connected last time when powered on again.
Charge
• You may hear a warning tone with the red light flashing when the headset is at low
battery level, please connect it to power source with the included charging cable for
charging.
• Red light steady lit = charging

Restore to factory settings

• When the headset is powered off, press and hold the "
the blue light flashes six times rapidly, then the factory settings have been restored.
" button for 3 seconds, then the
" button for 6 seconds, then the
" button for 5 seconds to let it enter
Red light off = fully charged
" button for 10 seconds until
"