Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

H-6425, H-6426
π
H-7857
REFLECTIVE BOLLARD
SLEEVE
INSTALLING REFLECTIVE BOLLARD SLEEVE TO
ROUND SAFETY BOLLARD POST USING FOAM STRIPS
NOTE: Post sleeve is not shown on these
drawings.
1. Remove all contents inside the bollard sleeve.
2. Lay the first foam piece across bollard post in
position (A) as shown in both top and side views.
Position the strip properly as shown. Foam should
extend down each side in equal length. On shorter
bollards, cut off strips near base. (See Figure 1).
3. Next, lay the second foam piece across bollard
post in position (B) as shown. Position (B) strip will be
on top of position (A) strip at the top center of the
bollard post (and 90° from it).
4. Hold post sleeve vertical and parallel to bollard
post and carefully slide open end down over top of
bollard continuing down to ground.
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTRUCTIONS
Figure 1
Foam
Strip
Pour le français, consulter la page 3.
B
Para Español, vea página 2.
TOP
Post
A
SIDE
Post
0421 IH-6425
loading

Resumen de contenidos para Uline H-6425

  • Página 2 H-6425, H-6426 π 800-295-5510 H-7857 uline.mx FUNDA REFLEJANTE PARA POSTE INSTRUCCIONES INSTALE LA FUNDA REFLEJANTE A UN POSTE REDONDO DE SEGURIDAD UTILIZANDO TIRAS DE ESPUMA SUPERIOR NOTA: La funda para poste no se muestra en este diagrama. Poste 1. Retire todo el contenido que está dentro de la funda para poste.

Este manual también es adecuado para:

H-6426H-7857