Eco-De ECO-2570 Manual página 24

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

MAINTENANCE DEVICE
1. Make sure the power switch off and disconnect the plug before the daily
maintenance.
2 . Do not use abrasives or solvents on the maintenance of the device.
3 . If there is dirt on the device wipe with a cloth wet .
5 . Do not use the device in very humid or dusty that can cause failure.
6. Install the machine on a level surface to avoid any dropping the device that causes
damage.
7. Do not use the device for more than 1 hour , make a off between time and time use.
8. The components must be kept clean , both sides tape must be cleaned and reduce
the accumulation of dirt. Ensure that footwear is clean before use . Use soap and a
damp cloth to clean the tape not use solvent. Wipe the sweat from his arms and
ribbonafter use .
9. The tape has been lubricated at the factory with a lubricant antistatic . It can lubricate
the device after 100 hours. Apply a special lubricator tapes the bottom of the tape
runner , lift Gently tape the base and apply lubricant .
10. To improve the use of the belt can be adjusted if you notice a deviation from the
direction of continuous use due subconsciously exerted pressure with legs , if note any
deviation from the tape to one side , adjust screws with allen key supplied , in partfront
of the base as shown in the drawing of a continued until the tape is properly centered.
11. If the device is to be used for a period long, please keep it in a dry, clean,
avoid having contact with dust.
12. Do not touch the power button or the power cord with wet hands. when
disconnect the machine, do not pull the cable. not put weight on the cable, twist the
device to prevent breakage, do not use the device if cord or plug make a good
connection.
Tabla de contenido
loading

Tabla de contenido