Power - Wacker Neuson VAL 300 Manual De Operación

All manuals and user guides at all-guides.com
Operation
2.8

Power

When battery power is low, the laser head will stop rotating and the low
battery LED next to the On/Off key will stay on.
Installing alkaline batteries
2.8.1 Use a coin or a screwdriver to remove the cover of the battery
compartment at the back of the laser.
2.8.2 Insert two alkaline batteries (D size or LR20), following the polarities
indicated at the bottom of the battery compartment. (The + contact is
rounded and raised). When replacing the batteries, change both at the
same time.
2.8.3 Replace the compartment and tighten with a coin or screwdriver.
Using rechargeable batteries
Charge the NiCd battery pack for 15 hours before first using the laser.
2.8.1 Insert the charger plug into the jack located at the back of the laser.
2.8.2 Plug the charger into an electrical outlet (110 volts or 230 volts).
2.8.3 Charge the battery for 15 hours.
Later recharges
The laser can be charged when working if electricity is available on the
jobsite. Simply plug in the charger and keep working. You can also
remove the battery, replace it with the alkaline battery pack and charge
the rechargeable batteries.
For optimum life of the battery, we recommend that you charge the
battery after it is fully discharged. To assure battery life, do not charge
over 20 hours.
Always store and charge the laser in a dry and covered place. The
battery and charger can be damaged if they become damp.
wc_tx000802gb.fm
EN-15
VAL 300