Maintenance And Cleaning - Jay Fusion Manual De Instrucciones

E E N N G G L L I I S S H H
EASY MAINTENANCE & CLEANING
Monthly cleaning and regular maintenance may help extend the
life of your cushion. During cleaning, component inspection is
recom-mended.
Check the cover for tears and excessive wear and replace if
ripped, torn, or otherwise not fully functional. Inspect the fluid
pad for punctures or any other abnormalities.
Check the foam base to ensure foam consistency. While
checking the fluid pad if you ever feel the fluid is firmer in one
area, simply knead the fluid back to its original consistency
and/or call your local authorized supplier.
To clean cover
1. Remove the cover from the foam base and turn inside out.
2. Machine wash in warm water and drip or tumble dry on low
heat.
No ironing required.
CAUTION– DO NOT DRY CLEAN COVERS OR USE INDUSTRIAL
WASHERS AND DRYERS TO CLEAN COVER. DO NOT STEAM
AUTOCLAVE. DO NOT BLEACH.
To refit cover after washing, reinstall the cover on the foam
base. Ensure the back of the cover matches up to the back of
the foam base.
NOTE: If utilized in an institutional setting, write the resident's
name witha permanent marker on the content label of the covers. This
will help to ensure the return of the covers after washing.
Use only JAY-designed covers on JAY cushions. The cover is an
important part of allowing the immersion into the fluid insert
which redistributes the pressure. Changing the cover will alter
this design and its efficacy.
To clean foam base
Remove the cover, fluid pad, and inner cover from the foam
base. Wipe lightly with a damp cloth. Do not use soap. Do not
submerge in water. Wipe off with a clean cloth. Let it
completely air-dry before reassembly.
NOTE: Avoid submersion of the foam base in water.
Reinstall the cover over foam base. Ensure the back of the
cover matches up to the back of the foam base.
To clean fluid pad
Remove the cover from the foam base. Remove fluid pad from
the inner cover and wipe with warm water and soap. Rinse with
a clean, damp cloth. Then wipe dry with a clean cloth.
CAUTION– NEVER SUBMERGE THE FLUID PAD IN ANY LIQUID.
CAUTION– AVOID HARSH CLEANING OR ROUGH HANDLING AS THIS
MAY LEAD TO A DEGRADATION OF THE FLUID INSERT.
If at any time, the outer cover, inner cover, Foam base, fluid
insert or any other component appears to be wearing or you
notice a degradation in the texture, contact your supplier/
Sunrise for evaluation and further instructions.
To clean the Air Cell Bladder (if applicable),
Reference the Air Insert Owner's Manual Supplement for proper
cleaning instructions.
©2020 Sunrise Medical JAY Fusion Cushion Owners Manual AU Rev. D

MAINTENANCE AND CLEANING

Laundry Care Symbols
REASSEMBLING THE JAY FUSION
CUSHION AFTER CLEANING
Follow cleaning and maintenance instructions as described in
"Easy maintenance and cleaning" then reassemble as follows.
Place the JAY Fluid or Air Cell Bladder on the inner cover
making sure that all Velcro® strip locations are aligned. A
misalignment or creation of an edge could cause an
unwanted pressure point which could lead to injury.
Insert the foam base / inner cover assembly into the outer
cover. Ensure that the zipper is at the rear of the foam base
where the pelvic loading area is located.
Fluid insert
4
Machine wash in warm
water (60° C)
Only non-chlorine
bleach, when needed
Drip dry
Do not iron
Do not dry clean
WARNING
AIR CELL INSERT N/A -
ON FUSION CORE
Foam base