Technical Specifications - VONROC CD507DC Traducción Del Manual Original

EN

TECHNICAL SPECIFICATIONS

Model No.
Charger cable
Recommended charger
adapter
Type plug side A
Type plug side B
Torque
Rechargeable Battery pack
Chuck capacity
No load speed
Sound pressure level L
Sound power level L
WA
Hand-arm vibration a
(screw driving without impact)
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-3
1. Machine
2. Charging socket
3. Battery indication light
4. Bit holder
5. Direction switch
6. On / off switch
7. Work light
8. Charger cable
9. Direction indication light
10. Screwdriver bit
3. OPERATION
The machine must be charged before first
use.
Charging the device (Fig. C)
• Plug the charger cable (6) (included) into an
adapter (not included).
• Plug the charger cable (6) into the machine.
(fig. J)
• Plug the charger plug into an electrical outlet
and wait for a while. The charger indication
light (5) will lighten up and show the charging
status.
6
CD507DC
CD816AA
5V d.c USB
500mA to 1500mA
USB type A
USB type C
Max. 5Nm
4V Li-ion 1.5Ah
¼" (6.35mm) hex
200 /min
55.5 dB(A) K= 3 dB(A)
PA
66.5 dB(A) K= 3 dB(A)
0.912 m/s K=1.5 m/s
h
2
LED Charger status
Red Battery charging in progress.
Green Battery charging finished, battery fully
charged.
After the battery is fully charged remove the char-
ger plug from the outlet and remove the small plug
from the device.
Fully charging the battery may take up to 2 - 3
hours.
Fitting and removing drills or screwdriver bits
(Fig. B)
The machine bit holder (4) is suitable for drills and
screwdriver bits with a standard ¼ inch hexagonal
shaft. To fit a screwdriver bit:
• Insert the screw driver bit (10) into the machi-
2
ne's bit holder (4), it will be hold by a magnet.
• The screw driver bit can be removed by pulling
it out of the bit holder again.
Adjusting the direction of rotation (Fig. D)
• Set the direction switch (5) to position '' in
order to drive screws or to use it for drilling.
• Set the direction switch (5) to position '' in
order to remove screws.
Tip: The direction indication light (9) on top of the
machine will also show the direction of rotation.
Switching the machine on and off (Fig. A)
• Pressing the on/off switch (6) will activate the
machine.
• Releasing the on/off switch (6) will stop the
machine.
• Move the direction switch (5) to the middle
position to lock the movement of the on/off
switch. It cannot be activated in this position.
The machine is equipped with electronic
overload protection function. When the
machine gets overloaded it will shut down
automatically. When this happens, please
wait for at least 5 seconds to let the
overload protection reset itself.
Spindle lock function
The machine is fitted with an automatic spindle
lock feature. When the on/off switch (6) is not
pressed, the bit holder (4) rotation is locked. Now
WWW.VONROC.COM