Danco Dual Flush Tank Lever Instrucciones

10071 I InstSheet_FINAL 4/28/10
1. Turn off water supply to toilet.
Flush toilet to drain water from toilet tank.
Disconnect chain (A) from existing tank lever (B).
Remove existing tank lever from toilet.
Note: Nut (C) may be reverse threaded, turn
clockwise to loosen.
FIGURE 1
2. Insert Lever Base (D) into the square opening on the Toilet Tank
from the front.
Slide Pivot Bracket (E) onto the Lever Base (D) from the inside
of the Toilet Tank, making sure the Pivot Post is oriented toward
the left. Secure Pivot Bracket (E) to Toilet Tank using Nut (F).
Note: Nut is reverse threaded.
Rotate counter clockwise to tighten.
D
FIGURE 2
4:35 PM Page 1
Instructions for Dual Flush Tank Lever
C
Pivot Post
E
F
3. Insert Handle (G) into Lever Base (D) from the front of the Toilet Tank. From the inside of the Toilet Tank, push Lift Bracket (H)
onto end of Handle (G), making sure to align the hole on the Handle and Lift Bracket. Secure through aligned holes using Pin (I).
B
D
G
A
4. Slide Lift Arm (J) over Pivot Post.
Note: Lift Arm (J) will rest inside Lift Bracket (H).
Dual Flush Lever-1
H
I
FIGURE 3
Pivot Post
FIGURE 4
J
H