Working Safely; Preparing The Product For Use; Assembling The Lamp; Switching The Uplight On / Off And Dimming It - LIVARNO 14156702L Instrucciones De Montaje, De Uso Y De Seguridad

manufacturer, its service representative or an
equally qualified professional.

Working safely

Install the light so that it is protected from
moisture and dirt.
Prepare carefully before assembly and allow
yourself enough time. Lay out all the individual
components and additional tools or materials
required so that you can see and reach them.
Remain alert at all times and always watch what
you are doing. Always proceed with caution
and do not assemble the lamp if you cannot
concentrate or feel unwell.
To disconnect the lamp completely from the
power supply, the mains plug must be discon-
nected from the mains socket.

Preparing the product for use

Assembling the lamp

Note: You will require a second person to help
with the assembly of the product.
Note: Place the floodlight on a soft surface (i.e. a
blanket) during assembly to prevent it from being
damaged.
Note: please ensure that you pull the cable slowly
through the base during assembly.
6
Remove the transport locks
Connect the sections of the tube
in place.
Carefully pull the mains lead
tube .
2
Be careful not to pinch the mains lead
running through the tube
Note: Be sure to screw in the section of tube
as far in as possible to ensure the light is stable.
Screw the standpipe
base .
6
Screw in the tube
2
the washers and the nut
from the tube
11 2
and screw
2
out of the
9
9
.
2
clockwise onto the
2
from below, tightening
with the tool .
7 8
Safety / Preparing the product for use
Note: Be sure to hold the tube
tightening the nut
Note: Make sure that the mains lead
inside the designated opening in the base
and cannot be squashed.
Set the uplight upright.
Guide the mains lead
Attach the uplight head
secure the locating screws
head wrench
Note: make a slight kink in the mains cable
when you screw the parts together.
Connect the mains plug
Plug the mains plug
been professionally installed.
Your light is now ready for operation.
Switching the uplight on / off
and dimming it
Press the button
uplight. To turn off the uplight, wait at least
3 seconds and then briefly press button
again.
The button
12
until the spotlight is the desired brightness by
dimming or increasing the luminosity.
Note: the uplight has a memory function. It
saves the most recently selected dimming level.
The lamp switches on again in the dimming
level most recently selected.
.
Switching the reading light
on / off and dimming it
Touch the touch button
the reading lamp. To turn off the reading lamp,
wait at least 3 seconds and then briefly touch
2
the touch button
The touch button
Hold the touch button
is at the desired brightness as the luminosity
increases or reduces.
tight when
2
.
7
into the tube
9
to the tube
1
with the socket
13
.
14
to the mains lead
10
into a socket that has
10
once to switch on the
12
is variable. Hold the button
once to switch on
5
again.
5
is continuously adjustable.
5
until the reading light
5
lies
9
6
.
2
and
2
9
.
9
12
12
GB/IE 17