Cleaning And Storage; Troubleshooting - Masterpro POWER DUO Manual De Instrucciones

EN
Dehydrate Fruit Chart
Ingredient
Preparation
Apples Core & slice, soak in pre-treatment
Bananas
Peel & slice, dip in pre-treatment
Remove stalks & slice
Berries
Remove stem and halve or quarter
Figs
Grapes Use seedless, remove stem & halve
Mangoes Peel & slice
Peel, half & remove stone
Peach
Peel & remove core
Pineapple

CLEANING AND STORAGE

Please Note!
As a guide, the following table shows you an overview for various foods:
- Do not use any sharp or harsh cleaning agents or cleaning pads to clean the device.
These may damage the surfaces.
1. Clean the racks (2) in the drawers (3) with detergent and warm water, or in the
dishwasher. To maintain the quality of the parts for a longer period of time, we
recommend you rinse them by hand.
In the case of stubborn dirt, soak in warm water and detergent beforehand.
2. Wipe down the outside of the device and the chambers (9) and heating elements
with a clean, damp cloth if needed.
Do not clean these parts in the dishwasher or put in water!
3. Allow all parts to dry completely.
4. Store the device away in a clean, dry location. Make sure that it is out of the reach of
children and animals when not in use for a prolonged period.
Single Zone Dual Zone
Temp
Time Time
60 °C 6 h
60 °C 8 h
60 °C 8 h
60 °C 6 h
60 °C 8 h
60 °C 6 h
60 °C
6 h
60 °C 6 h
30

TROUBLESHOOTING

If the device does not work properly, go through these steps to see if the problem can
be fixed. If the problem persists after following the steps below, contact the customer
service department.
Do not attempt to repair an electrical device yourself!
The device is not working.
The mains plug is not inserted in the plug socket correctly.
Make sure the mains plug is inserted correctly
If the plug socket is defective.
Try another plug socket.
There is no power voltage.
Check the fuse of the mains power.
The drawers (3) are not inserted correctly.
Slide the drawer fully into the chambers (9).
The fuse in the fuse box is triggered.
There are too many devices connected to the same circuit.
Reduce the number of devices in the circuit.
The food has not been cooked evenly. The drawer (3) is too full.
Reduce the amount of food. Fill the drawer to no more than 1/3. This ensure that the
air has sufficient space to fully circulate around the food.
The items of food are piled on top of one another.
Spread the food around and mix it from time to time.
Different foods with different cooking times or temperatures have been prepared in one
drawer (3).
Separate the different foods and spread them across both drawers. Set the correct
temperature and cooking time for them respectively. With the MEAL function, they will
finish cooking and be ready at the same time.
The set cooking time was too short or the temperature too low.
Increase the cooking time or temperature.
31
EN