Code Identification; Reset To Factory Settings - GE 37123 Manual De Instrucciones

Using Your Remote

Code Identification

Reset to Factory Settings

1. Press and hold down the SETUP
button on the remote until the red
light on the remote control turns on.
Release the SETUP button. The red
light will remain on.
2. Press and release the desired device
button (TV, dvd, strm, aux, b-ray, cbl,
sat, amp) you would like the code for.
3. Press and release the ENTER button.
4. Press and release the #1 button.
Count the number of times the
remote light flashes. This is the
number corresponding to the first
digit of the code. Repeat the process
by pressing the #2, #3 and #4
buttons for the remaining digits.
5. Press and release the ENTER button
to exit this mode.
1. Press and hold down the SETUP
button on the remote until the red
light on the remote control turns on.
Release the SETUP button. The red
light will remain on.
2. Press and release the MUTE button.
3. Press and release the number #0
button. The red indicator light will
flash twice.
12