Quick Setup - Alto Professional Ipa Manual Del Usuario

BOX CONTENTS
•
iPA Music System
•
Microphone
•
Microphone cable (XLR)
•
Power cable
•
Quickstart Guide
•
Safety Instructions & Warranty Information Booklet

QUICK SETUP

1. Connect iPA Music System's POWER INPUT to power outlet using the included power
cable. (Do not power on iPA Music System yet.)
2. Optional: Connect microphone to INPUT using standard XLR or 1/4" cable.
3. iPad (3rd generation) and iPad 2 users: Power on your iPad (not included). Slide it into
plastic "sled" and gently connect it to the DOCK connector.
iPad users: iPA Music System's plastic "sled" has a plastic "rail" on each side to
accommodate the new iPad and iPad 2, which are thinner. Use a screwdriver, your
thumbs, etc. to remove these rails before using it (see the illustrations here as well as in
the included Quickstart Guide poster). Power on your iPad (not included). Slide it into the
sled and gently connect it to the DOCK connector.
iPad 2
&
4. Set both volume knobs (INPUT VOLUME and DOCK VOLUME) at minimum setting.
5. Turn iPA Music System's POWER SWITCH to ON.
6. Play music on iPad. Adjust DOCK VOLUME to a reasonable volume level. The
SIGNAL/PEAK LED will illuminate red.
7. Optional: Talk into microphone (if one is connected to INPUT). Adjust INPUT VOLUME to
reasonable volume level.
Note: You can connect an extension speaker (another iPA Music System, not
included) to the MIX OUT using a standard XLR cable. If you do this:
• So the extension speaker's playback level matches that of the main speaker,
set the extension speaker's INPUT VOLUME at the "9 o'clock" knob position.
• You can set which channel (left, right, or summed mono) is sent to your
extension speaker. See OUTPUT CHANNEL description under REAR PANEL
OVERVIEW for more information.
iPad
rd
( 3 generatio n )
iPad
A
2
B