Midwest Cat Playpen 130 Instrucciones De Montaje página 5

Next, secure each End Panel to the Top Panel. Each End Panel has two hooks, one in the front and one in the back;
11.
secure these over the Top Panel. The Top Panel has a hook in the middle; secure this over the End Panel.
Wrap the hooks on the Side Panels over the Top Panel.
Attach the casters. The casters will be placed in the four corners of the base on two intersecting wires. NOTE: It might be helpful
12.
to tilt the pen or lay it on its side for this step. Place the Plastic Plate (F) on the underside of the intersecting wires so the
bottom wire fits in the "channel." Place the Steel Plate (G) on the top so the wire also fits in the "channel." Place the Caster (E)
up against the Plastic Plate so all the holes align.
underside, place a Washer (J), then a Lock Washer (I), up the threads of the Screw until they reach the Caster's metal plate.
Secure the Screw and Washers with a Nut (K).
Attach the bed to one of the shelves by looping the hook & loop tabs through the wires in the corners of the shelf and securing
13.
them on the underside of the bed. Place the shelves in the desired location within the pen. The shelves hook to the horizontal
wires in the front and back of the pen. Be sure to engage the safety hook on the long side of the shelf around the Side Panel.
Safety Hook
Wrap the middle hook of the Top Panel over the End Panel.
Insert a Screw (H) in the top of each hole in the Steel Plate. From the
5.