Idiomas disponibles
Idiomas disponibles
PEDAL ADJUSTMENT RANGE
19
Loosen the Bolts on the Pedal Plates. Adjust to your desired position using the alignment lines and
tighten the Bolts to lock the Pedal Plates in position.
20
Align the holes on the Pedal Adjustment Fins with the T-Nuts previously installed in STEP 01a/01b. Bolt
through and secure using 2 x M8 Bolts and Washers. Repeat on the other side.
PEDAL ANGLE ADJUSTMENT
Repeat
on Other
Side
21
Adjust the pedal assembly to your desired angle and align the T-Nuts previously installed in STEP 15a
with the holes on the Pedal Adjustment Fins. Bolt through and secure with M8 Bolts and Washers.
20
PARTS:
• • NIL
PARTS:
• • 4 x M8 16mm Bolts
Repeat
on Other
Side
• • 4 x M8 Washers
PARTS:
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers
)
A
B
(
)
Butt-Kicker T-Nut Locations
A) Install 2 x T-Nuts into the bottom channel of the Front Seat Slider Member for the Buttkicker Mount Pole. Install 2 x T-Nuts
22
into the top channel of both Seat Slider Members and attach Felt Pads to the bottom of the Seat Slider Members.
B) Align the holes on the Seat Slider End Plates with the threaded holes on the Seat Slider Members. Bolt through and secure
with 4 x M8 Countersunk Bolts.
)
A
23
A) Align the front Seat Slider Assembly with the T-Nuts previously installed in STEP 01a & STEP 01b.
B) Bolt through and secure with 2 x M8 Ratchet Handles.
)
A
24
A) Align the Rear Seat Slider Assembly with the T-Nuts previously installed in STEP 01a & STEP 01b.
B) Bolt through and secure with 2 x M8 Ratchet Handles.
Video Instruction: bit.ly/nlrbuild
PARTS:
)
• • 6 x T-Nuts
• • 4 x Seat Sliders
End Plates
• • 4 x M8 16mm Countersunk Bolts
• • 4 x Sticky Felt Pads
(35mm x 40mm)
)
B
PARTS:
• • 2 x Seat Slider Ratchet Handles
Repeat
on Other
Side
)
PARTS:
B
• • 2 x Seat Slider Ratchet Handles
Repeat
on Other
Side
21
