Idiomas disponibles
Idiomas disponibles
User Guide for IN.28.106
Free user Mode
Accepts any user card, if the lock is available.
Programming card authorization.
1- Select the Switch in the positions D e A (automatic lock) or M (manual lock)
2 - After placing the battery (4x AA batteries 1.5 V), pass the Mifare card, orange, the lock will beep twice, validating
the card.
Note: This card is referred as authorization card, which allows you to create emergency cards.
Programming the emergency card.
3-
Pass the authorization card (orange), the LED flashes blue, approach a gray card, two beeps are emitted by the
reader.
Note: This card (gray), is the emergency card. It is advisable to be identified.The card is aimed at opening the lock in
case of lost / stolen card by the user. To unlock the lock with the emergency card, swipe the card twice for the reader.
The card lock is associated with the previously unusable. The lock is configured to use a free-use, which allows the lock
code using any card use (gray).
Utilization of the user card.
4-
Pass the user card on the reader, a beep sound and the lock is activated. Automatically lock is uniquely associated
with this card user. The card does not allow the activation of other locks.
Note: After opening the lock with the respective card for use, it is again available for further use.
General note:
If you block the lock when the door it´s open, the lock enters in safe mode, when the door closes . And you hear a beep
alarm for 60 seconds, or until the card is passed again.
Assign user Mode
The lock will only work with an authorized user card.
Programming card authorization.
1- Select the Switch in the positions S e A (automatic lock) or M (manual lock)
2 - After placing the battery (4x AA batteries 1.5 V), pass the Mifare card, orange, the lock will beep twice, validating
the card.
Note: This card is referred as authorization card, which allows you to create emergency cards.
MASTER card programming.
3-
Pass the
autorization
emitted by the reader
.
User cards creation.
4- Pass the MASTER card , a beep is emitted and the lock is activated. Pass the MASTER card again, the LED will blink in
blue, pass the MASTER card again, the lock opens and it will blink in blue. Then pass the user card you want to activate.
Note: To delete the card, repeat Point 4.
(3x MASTER) with the lock open.
Advanced Settings:
Inside the lock have the RESET button (SET), this enables you to override all settings of the lock. After the reset done, you
must perform steps 1 and 2.
card
(orange), the LED will blink in blue, then pass one of the gray cards, t
Switch
S D M A
Switch
S D M A
wo beeps are
3/4
