Troubleshooting - Asept-Air LIFE CELL 1550 Manual Del Propietário

10.2. HEPA/Carbon filter installation:
Begin by resting bottom edge of filter inside of unit and then gently push the filter into the housing until it fully
seats; see illustration 2 below.
10.3. Prefilter installation:
Place the prefilter into the housing against the HEPA/Carbon filter. Turn the swivel locking tabs to secure in
place; see illustration 3 below
10.4. Front cover installation:
Place the bottom tabs of the front cover into the slots on the bottom of the housing. Push the cover inwards and
using your thumbs press inwards on the upper outer corners of the cover until you feel it "pop" into place. Release
pressure and cover should be locked in place; see illustration 4 below. If unit does not chime when connect to a
power source check to make sure front cover is fully secured in place.
1

11. Troubleshooting

Problems
The unit does not turn on.
No air comes out
Expected cleaning effect is
not achieved
Air outlet smells
unpleasantly
Should the above mentioned remedies not work, please contact Asept-Air. DO NOT attempt to fix or repair
the internal components of the unit.
Asept-Air Inc. Saint-Laurent, Québec H4R 2A2
2
Cause
1.Not properly plugged in
2.Front cover not secure
3.Remote control batteries dead
Air inlets or outlet blocked
1.The unit is not placed properly or is
blocked by other objects
2.The filters are dirty
1. Odors are too strong to be removed
in one pass.
2. The filters are dirty
www.asept-air.com
3
Solution
1.Plug into electrical outlet
2.Secure front cover
3.Replace batteries
Remove any objects blocking air
inlets or outlet.
1. Reposition unit or remove any
blockage.
2.Clean or change the filters
1.Operate the unit for a certain
period
2.Clean or change the filters
+1 (514) 731-1858
11
4