npe WASP-N Guia De Inicio Rapido página 4

TITLE: Getting Started with WASP-N
DATE:
iii. Set the Static Gateway IP to the value assigned by your network
8. Click Apply Settings (located in the upper-right of the page).
9. Click the "Back" button to return to the WASP(s) page.
10. Click the WASP-N and select "Disconnect WASP" from the pop-up menu.
11. Close the app and power off the WASP-N. (See the section below to test your
configuration).
CONFIGURE THE WASP-N USING THE WASP USB CONFIGURATION
UTILITY
Follow the steps below to configure your WASP-N to join your Wi-Fi network using the
WASP USB Configuration Utility downloaded from the WASP Forum.
1. Install the WASP USB Configuration Utility on your Windows PC.
2. Start the WASP USB Configuration Utility from your PC Desktop.
3. Plug the WASP-N into a USB port using a micro-USB cable. The area to the left will
fill with the pre-set data read from the WASP-N.
4. Locate the area named Infrastructure Network and setup your network
parameters:
a. Set Security Type to the security type used on your Wi-Fi Access Point.
b. Enter the SSID (or network name) of the Wi-Fi Access Point into the SSID
field.
All manuals and user guides at all-guides.com
© North Pole Engineering, Inc. 2019
10/7/2019
i. Set the Static IP to the value assigned by your network
administrator.
ii. Set the Static Subnet to the value assigned by your network
administrator.
administrator.
Page 4 of 42
Quick Start Guide
Revision: 1.6
PAGE: 4 of 42