ledscom LC-L-249 Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. Loosen the two cap nuts (1) and
remove the mounting plate (2) from the
light. Then carefully lay the light on its side
so that it cannot be damaged.
3. Drill holes in the mounting base and
insert two dowels there. The positioning of
the holes should correspond to those of the
screw holes (3) on the mounting plate.
Make sure that the dowels are flush with
the substrate.
4. Then fix the mounting plate (2) to the
mounting base using two screws.
5. Connect the wires of the cable according
to "Figure 2".
6. Place the light back on the mounting
plate (2). Then retighten the cap nuts (1) to
fix the light to the mounting plate. The
installation is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
1: Cap nut
2: Mounting plate
Figure 2
Ceiling light (LC-L-249) - Assembly instructions
3: Screw holes
05/2022