MaxPro MPBDP16 Manual Del Usuario página 9

All manuals and user guides at all-guides.com
D D rill Press MPBDP16 User Manual
7
9
8
16
8
15
10
9
17
25
Before starting the equipment
1. Assembling the machine
Position the machine base (1).
Fasten mounting flange with pillar (2) using three screws (3) and washers to drill base (1).
Push the drill table (4) with drill table clamp shaft onto the pillar (2) (Fig. 3). Lock the drill table into the
desired position using the clamping screw (5).
Place drill head (6) with V-belt cover (7) and motor (8) onto the drill pillar and fasten using the Allen screws
(20).
Screw the three ball-shaped handles (9) onto the feeder cross handle.
Note: All bare parts are greased in order to protect them from corrosion. Before mounting the drill chuck
(10) onto the spindle (11), both parts must be completely degreased using an environmentally friendly
solvent. This ensures optimal transmission of power.
2. Installing the machine (Fig. 1)
Before you use the drill for the first time it must be permanently fixed in position. Use both mounting
holes (12) in the base plate to do this. Ensure that the equipment is freely accessible for operation,
adjustment and maintenance.
Note: The fixing screws may only be tightened to a point where they do not distort or deform the base
plate. Excessive tension can lead to fracture.
3. Hinged chip guard (Fig. 4-6)
Unscrew the three screws (21). Push the transparent cover (23) into the groove of the red mounting frame
(24) and fasten it again with the screws (21). Then use the clamping screw to fasten the folding chip guard
(13) to the machine. Finally swing up the chip guard, push the scroll chuck (10) with a jerk onto the taper
and check that the tool is securely seated.
The height of the cover (23) is infinitely adjustable and can be locked using both thumb screws (22).
The chip guard (13) can be flipped upwards to change drill bits, however ensure that the chip guard
(13) is back in its initial position before restarting the equipment.
4. Prior to using the machine for the first time
Ensure that the voltage of the mains supply complies with the specifications on the rating plate. Connect
the equipment only to a socket with the properly installed earthing contact. The drill is equipped with a
no-volt trip that is designed to protect the operator from an undesired restart following a drop in voltage.
Should this happen, the equipment must be physically restarted.
9
GB