Probuilder 69366 Manual De Instrucciones página 56

5. Choose the correct impact socket as
needed and mount it onto the anvil (B).
(See Figure 2)
Figure 2
WARNING: Only use impact sockets that
have an RPM rating equal to or greater than
the tool itself.
6. Connect air supply hose to the male plug.
Set the air pressure at 90 PSI. (See Figure 3)
Figure 3
NOTE: Working pressure refers to the air
line pressure set to tool when tool is under
working conditions.
56
Operation instructions
1. How to install/tighten threaded fasteners.
Push the valve stem (F) forward as
indicated by "F" marking on the housing.
Press the trigger (C). Then the tool anvil
(B) runs clockwise. (See Figure 4)
Figure 4
2. How to remove/loosen threaded
fasteners. Push the valve stem (F)
backward as indicated by "R" marking on
the housing. Press the trigger (C). Then
the tool anvil (B) runs counterclockwise.
(See Figure 5)
Figure 5