NuTone 744SFLNT Manual Del Usuario página 2

Ventilador empotrado con sensor de humedad y lámpara fluorescente
Ocultar thumbs Ver también para 744SFLNT:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

PLAN THE INSTALLATION
POWER
CABLE
DAMPER/DUCT
CONNECTOR &
CEILING
JOIST
FINISHED CEILING
Typical Installation
The unit can be installed anywhere between ceiling joists using mounting
brackets provided. Install in a flat ceiling only.
INSULATION
(Can be placed around and
over fan housing.)
FAN
HOUSING
4-IN.
ROUND
*
DUCT
*
Purchase
4-IN. ROUND
ELBOW(S)
separately
Two of the most common ways to
connect ductwork to the unit.
The unit will operate most quietly and efficiently when located where
the shortest possible duct run and minimum number of elbows will be
needed.
Use a roof cap or wall cap that has a built-in damper to reduce backdrafts.
Plan to supply the unit with proper line voltage and appropriate
power cable.
COOKING AREA
Do not install above or
inside this area.
o
45
NOT FOR USE IN
A COOKING AREA.
Do not install in a cooking area.
The unit must not be installed above or inside the cooking area shown.
All manuals and user guides at all-guides.com
4" ROUND
4" ROUND
HOUSING
DUCTWORK
MOUNTING
BRACKET
TRIM RING / BAFFLE
ROOF
*
CAP
*
o
45
Cooking
Equipment
Floor
INSTALLATION
CARDBOARD PROTECTOR
1. Install mounting brackets.
Slide the adjustable mounting brackets into the bracket channels
on the housing.
Bend the tabs on the cardboard protector and insert protector
into opening in housing.
NOTE: The cardboard protector shields the inside of the housing
from drywall spray and construction dust. Do not remove it until
after construction is completed.
WALL
*
CAP
2. Mark mounting location.
Position unit between joists and extend mounting brackets.
IMPORTANT: Position brackets so there will be an 1/8" gap
between bottom of housing and ceiling material. Mark the top
of keyhole slot on all four mounting brackets.
3. Pound in nails.
Remove unit temporarily, and pound nails partially into joists at
all four marked locations.
MODEL 744SFLNT
Page 2
1/8" GAP
Tabla de contenido
loading

Tabla de contenido