oneConcept 10026445 Manual Del Usuario página 10

Removing the Motor Locking System
• Move the handle towards the position indicate by
the arrow.
• Remove the motor locking system.
How to properly load the Spin Dryer
• Load each article of clothing in an extended manner. The ligh-
test articles, such as socks, slops, handkerchiefs, etc. should be
put in the middle of the load.
• Try to prevent open spaces between items when loading the
clothes, as this can potentially cause an unbalanced load.
• After loading, insert the round safety Cover inside the inner
tub, on top of The clothes. Do not use an excessive amount of
force cover inside the inner tub on top of the clothes.
• The safety cover prevents clothes from leaving the inner tub
and potentially damaging the machine. Also, pressing down
on the clothes with the safety cover can help balance the load.
Operation
1. Load each article of clothing in an extended manner. The lightest articles, such as socks, slops, hand-
kerchiefs, etc. should be put in the middle of the load.
2. Try to prevent open spaces between items when loading the clothes, as this can
potentially cause an unbalanced load. After loading, insert the round safety Co-
ver inside the inner tub, on top of The clothes. Do not use an excessive amount
of force cover inside the inner tub on top of the clothes.
3. The safety cover prevents clothes from leaving the inner tub and potentially
damaging the machine. Close the lid (2). Move the switch handle (5) to the on
position (1 ). The machine will start automatically.
4. Important: The spin dryer is equipped with a special safety feature, which pre-
vents you from moving the switch handle to the on position (1) while the lid (2) is
5. open. If the spin dryer starts shaking or moving, stop it by turning the switch
handle to the (0) position, balance the load and start again.
6. When the spin dryer starts, water will start flowing out of the drain spout (7). Place
small container under the drain spout to catch the water. When water stops flowing
out of the drain spout (normally in about 2-3 minutes, depending on the type of
clothes), you stop the machine by moving the switch handle (5) to the (0) position.
7. Open the lid (2) when the inner tub (4) has come to a complete stop. The spin
dryer is equipped with a special electronic lock which does not allow the lid to
be lifted while the inner tub (4) is still spinning. Do not try to force it open before
it unlock after 10 seconds time delay. The inner tub may spin very slowly for up
to around 10 seconds when plugged in, before you turn the machine. This is not
a product defect, nor does it present any safety issue due to the extremely low
speed. lt is due to a small amount of electricity stored in the capacitor.
10
All manuals and user guides at all-guides.com