SEVERIN 2057 Instrucciones De Uso página 12

select the desired cooking time.
∙ For overhead baking or grilling, either the
upper or the upper and lower elements
may be selected.
∙ The switch settings (upper heat/lower
heat) may be changed during the cooking
process.
∙ After the pre-programmed cooking time
has elapsed, the timer will automatically
switch off the heating elements.
∙ To switch off the appliance earlier, set the
timer to ' '.
∙ Always use the door handle to open
the hot door after use. When removing
the baking tray or rack, use the handle
provided. Always place the baking tray
and rack on a heat-resistant surface.
∙ Remove the plug from the wall socket
after use.
Cooking times
The grilling/cooking times listed are
approximate times only, as each food to
be grilled or cooked is of a different nature
and consistency; please also refer to the
information contained on the food packaging.
Temperature
Food
Pizza (deep-
frozen)
Toast Hawaii
Baguette
(deep-frozen)
Cleaning and care
∙ Before cleaning the appliance, ensure it is
12
All manuals and user guides at all-guides.com
Grilling/
cooking
/ setting
time
200°C 9-10
mins.
220°C 10-14
mins.
200°C 14-15
mins.
disconnected from the power supply and
has completely cooled down.
∙ To avoid the risk of electric shock, do not
clean the appliance with water and do not
immerse it in water.
∙ Do not use abrasives, harsh cleaning
solutions or spray-type oven cleaners.
∙ The exterior of the housing may be
cleaned with a damp, lint-free cloth.
∙ The baking tray and rack may be cleaned
using hot water and a mild detergent, or in
a dish-washer.
∙ The crumb tray may be taken out for
cleaning. Any large accumulation of fat
in the tray should fi rst be cleaned up with
a paper towel. Make sure that the tray
is refi tted in its proper position under the
heating elements.
∙ The inner glass plate of the door may
also be removed for cleaning. Open the
door to the horizontal, loosen the screw
and pull the glass plate out, cleaning
and drying it thoroughly afterwards. To
replace, fi t it between the guide slots in
the glass door, ensuring that it is properly
located above the centre guide slots and
below the two outer slots. When the plate
is replaced, ensure it is the right way up
– ie the open side of the rubber seal (with
the fl ap) downwards against the fi xed
glass plate. Retighten the screw.
Disposal
Devices marked with this symbol
must be disposed of separately
from your household waste, as
they contain valuable materials
which can be recycled. Proper disposal
protects the environment and human health.
Your local authority or retailer can provide
information on the matter.