Topcom ULTRA RANGE Serie Manual De Usuario página 37

In the event of danger, disconnect the device from the 230 V mains immediately.
Display remains dark.
No sound.
The symbol is flashing.
The base station or handset
does not ring.
No connection despite good
sound quality.
Calls cannot be forwarded on a
PBX.
Telephone does not
respondwhen keys are pressed.
All manuals and user guides at all-guides.com
Battery packs inserted incorrectly.
Batteries not charged.
Handset is switched off.
No power.
Telephone cable incorrectly connected or
defective.
The line is engaged by a different handset.
Handset is out of range.
The base station has no power.
The handset is not registered to the base
station.
The ringer volume is off or too low.
The dialling mode is incorrect.
The flash time is too short.
Programming error.
Check the connector of the battery pack (see "2.3
Commissioning the charging station S1200c").
Charge the batteries.
Switch on the handset (see "4.2 Switching the handset
on/off").
Check that the devices has the correct power supply.
Check if the handset is activated (Only Outdoor
S2010c). See "2.6 OUTDOOR S2010c Handset
activation"
Check the connection of the telephone cable (see "2.1
Commissioning the base station").
Wait until the other handset hangs up.
Move closer to the base station with the handset.
Check the power connection to the base station.
Register the handset to the base station (see "9.1
Registering an additional handset").
Set the ringer volume (see "4.16 Setting the ringer
volume on the handset" and "7.1 Setting the ring
volume on the base station").
Check the dialling mode (see "8.4 Setting the dialling
mode").
Set the device to a long flash time (see "8.2 The flash
key (R)").
Remove the batteries and then insert them again after
1 minute.
37